![]() Tone will sound for 1 second, and the keypad will go into “lock-down” mode for 40 seconds. After 40 seconds, the keypad will beep 3 three times and go into “idle” mode. The keypad remains active for 40 seconds after entering a valid code: pressing any key on the keypad while the gate is in motion will stop the gate pressing any key while the gate is stopped will cause the gate to reverse direction.When a valid code is entered, the STATUS light will blink rapidly.The keypad illuminates and beeps at the press of any key.Consult the dealer or an experienced radio/TV technician for help.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and the receiver.Reorient or replace the receiver antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in particular installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The recommended minimum distance between the gate and keypad is 10 ft.įCC WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. SAFETY NOTE: Never install the keypad where a person can reach through the gate to activate it, or where a person can touch the gate while activating the keypad. As a wireless keypad it can be used with any gate or garage door opener and must be used in conjunction with the GTO garage door receiver kit (part # RB709U-NB). The GTO Digital Keypad is a multipurpose keypad that can work with other applications in addition to GTO gate openers and locks. ![]() That are relativity close to cell towers or airports may receive intermittent interference and require hard-wiring. IMPORTANT: Your keypad may need to be hard wired due to the fact that it must accept interference according to FCC regulations listed below. Before permanently mounting the keypad, please program the keypad and test its range. Be sure to read the directions carefully and completely. Thank you for purchasing the GTO Digital Keypad. Instructions for Wired and Wireless Installations (FM137-G3 only)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |